cancel
Showing results for 
Search instead for 
Did you mean: 
Create a Post
Highlighted

R80.20 Installation Error "doAutoPartition" Exception Occured on 4800 appliance

Hi,

I have issue very similar to the one described in older post (https://community.checkpoint.com/t5/General-Management-Topics/R80-10-Installation-Error-quot-doAutoP...) - i.e. I am getting exactly the same error message.

Differences are that this is a CP 4800 appliance and version I am going to install is R80.20.

I made USB few times using different versions of ISOmorphis as well as used USB-attached DVD - all the same.

Ran a HW Diagnostics Tool – all tests OK …

I was using ISO image “R80.20 Gaia Fresh Install for Security Gateway and Standalone T101” – the same image was used for installation of over 10 other gateways on 4000 appliances.

SHA1 checksum for the image is OK.

 

Any ideas? 

I have none at this moment ... 😕

0 Kudos
1 Reply
Highlighted
Admin
Admin

Re: R80.20 Installation Error "doAutoPartition" Exception Occured on 4800 appliance

Best to get the TAC involved with this.
0 Kudos