Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted

MEP VPN Migration

Hi Guys,

I need to migrate an old 4400 appliance (running as VPN RAVPN gateway) to a new 5600 appliance and this VPN solution is using MEP (Multi-Entry Point Solution). Besides from replicating the configuration of the 4400 to 5600, do I need to export some files or profiles from the 4400 and the 5600?

Thank you very much for the help.

 

0 Kudos
5 Replies
Highlighted
Admin
Admin

Re: MEP VPN Migration

Is the 5600 going to adopt all the same settings (including IP addresses) of the 4400?
0 Kudos
Highlighted

Re: MEP VPN Migration

Hi @PhoneBoy , Yes, that is the plan, but I am not sure if there are any files inside the 4400 that I need to export and import to the new 5600 as far as the MEP solution is concerned? Thanks

0 Kudos
Highlighted
Admin
Admin

Re: MEP VPN Migration

If you modified any files directly, those may need to be copied or the configuration changes applied.
This could include but is not limited to:
$FWDIR/conf/trac_client_1.ttm
$FWDIR/conf/trac.config
0 Kudos
Highlighted

Re: MEP VPN Migration

Thanks for the reply @PhoneBoy,

Is there any profile/s that are installed in the endpoint machines for the MEP solution? Where can I find that?

Thank you so much.

0 Kudos
Highlighted
Admin
Admin

Re: MEP VPN Migration

They would be part of the site configuration which is stored on the client, most likely obscured.
I believe it is the same filenames on the Endpoint, but obviously a different directory that I don't recall offhand.
0 Kudos