cancel
Showing results for 
Search instead for 
Did you mean: 
Create a Post

How reset to factory default - from maintenance mode

Hi,

Resetting checkpoint 1200R to Factory default (Physically by pressing the small button), make the device enter to maintenance mode. (connected by console cable)

How can i reset to factory defaults ???

currently stack at this maintenance mode.

cat logs/boot_log  :

[Expert@MAINTENANCE_MODE]# cat check /logs/boot_log
cat: can't open 'check': No such file or directory
Kernel boot messages:
---------------------
 memory: 000000002e000000 @ 0000000020000000 (usable)
 memory: 000000000084e000 @ 0000000000100000 (usable)
 memory: 0000000000452000 @ 000000000094e000 (usable after init)
Wasting 14336 bytes for tracking 256 unused pages
Initrd not found or empty - disabling initrd
Using passed Device Tree <8000000000080000>.
software IO TLB [mem 0x01e0c000-0x01e4c000] (0MB) mapped at [8000000001e0c000-8000000001e4bfff]
Zone ranges:
  DMA32    [mem 0x00100000-0xefffffff]
  Normal   empty
Movable zone start for each node
Early memory node ranges
  node   0: [mem 0x00100000-0x00d9ffff]
  node   0: [mem 0x00f00000-0x0

...
TO READ THE FULL POST it's simple and free