Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Copper

Heartbeat configuration Bond port, Active/Backup or 802.3 AD recommended?

Heartbeat configuration Bond port, Active/Backup or 802.3 AD recommended?

0 Kudos
7 Replies
Highlighted
Admin
Admin

Bond is the way to go here.
Believe that's been the recommendation for a while here.
0 Kudos
Highlighted
Copper

11.png

For synchronous interface, Bond, shall I choose active-Backup or 802.3AD?

 

0 Kudos
Highlighted
Admin
Admin

802.3ad I believe is active/active, which gives you more throughput, active/backup does not.
Either should work.
0 Kudos
Highlighted
Copper

So, the sync port doesn't need a lot of throughput, you also recommend 802.3AD?
0 Kudos
Highlighted
Admin
Admin

In a busy environment, it can use up to 2GB, which if you're using 10GB ports, may be fine, but something to consider if you're using 1GB ports.
Really, it's up to you.
0 Kudos
Highlighted
Copper

Ok, thank you very much
0 Kudos
Highlighted
Admin
Admin

802.3 AD is the recommended, although you will not benefit of load sharing, cause it is multicast / broadcast (depending on ClusterXL mode) traffic anyway. It will not be balanced.

For full set of references, look here: https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solut...

 

0 Kudos