cancel
Showing results for 
Search instead for 
Did you mean: 
Create a Post

Configuring the ISP redundancy

I have an appliance 3000 running GAIA R80.10 and would like to configure ISP redundancy. My question is, is it possible to have this setup in this appliance ? the documentation does not have that much information.

waiting for your responses.

0 Kudos
6 Replies
Admin
Admin

Re: Configuring the ISP redundancy

Yes, instructions are in the ClusterXL Admin Guide.

ClusterXL R80.10 (Part of Check Point Infinity) Administration Guide 

0 Kudos

Re: Configuring the ISP redundancy

Thanks for the guide its really helpful. I have just discovered that the first gateway was not configured in cluster. Is it possible to change it and make it primary without starting the configurations again?

0 Kudos
Admin
Admin

Re: Configuring the ISP redundancy

Just set the cluster member you want as primary with a higher priority (or adjust the other one with a lower priority).

This is done in the cluster object under Cluster Members.

0 Kudos

Re: Configuring the ISP redundancy

Thanks for the info. I was able to work on the redundancy. looking out for another checkpoint project.

0 Kudos

Re: Configuring the ISP redundancy

Are you able to reduce the redundancy? how did you actually do it? I want to do the same.

0 Kudos
Highlighted

Re: Configuring the ISP redundancy

I configured mine as load balancing not primary and secondary. its able to share the load. Can you give me more details on your configuration? 

0 Kudos