Blink with Clish configuration script

[Bernhard_Sayer]

Hi!

Have anyone used BLINK with custom clish configuration script (referenced in install_content.sh)?

I tried it many times (source R77.30 with blink image R80.10) without luck. The install process works fine and all settings in answers.xml are executed, except the reference to install_content.sh in section user_updates.

I executed BLINK with this command:

./blink -i /var/log/blink/blink_image_1.0_Check_Point_R80.10_T462_Jumbo_T103_Gateway.tgz -b /var/log/blink/blink_updates_R80.10.tgz -u /var/log/blink/blink_custom_content.tgz -a /var/log/blink/answers.xml -d /var/log/blink/tmp --reimage

In blink_custom_content.tgz i added the bash script install_content.sh (based from sk120193) and clish_commands.txt (with some basic clish commands). 

After executing the blink command, these two script files are extracted in the sub direcorty user_updates, but none of them were executed ….

In the attached logfile of BLINK, i couldn´t find any hints regarding these two scripts 😞

Any help would be greatly appreciated!

BR,

Bernhard

[Bernhard_Sayer]

found the issue - i hope i don´t loose any kudos for that rookie problem 

Doing the following before archiving the scripts did the job:

chmod +x install_content.sh
dos2unix install_content.sh
dos2unix clish_commands.txt

[PhoneBoy]

No, it's quite alright. Good you found the solution and shared it, even if it was something simple.