topic Re: Lan1 and lan2 are bridge mode. IPS doesn't work in Spark Firewall (SMB)

Lan1 and lan2 are bridge mode. IPS doesn't work

Lei_Liu — Wed, 23 Mar 2022 08:10:39 GMT

[15:09] Lei Liu

Hi expert, our SE has a POC on 1600 SMB apliance, he enabled FW, IPS, AV/AB software blades on the 1600 apliance of central managemnt. 1.wan and Lan2 are route mode. IPS works well. it's ok. 2.Lan1 and lan2 are bridge mode. IPS doesn't work Question: we want to konow that "Lan1 and lan2 are bridge mode. IPS doesn't work " this is a limition?

Re: Lan1 and lan2 are bridge mode. IPS doesn't work

G_W_Albrecht — Wed, 23 Mar 2022 08:59:24 GMT

Bridge mode is not the cause - WAN to LAN traffic is inspected as set in IPS Protection Engine Settings. But not LAN to LAN: In Default mode, LAN to LAN Deep Packet Inspection is off - you can enable it in Advanced Settings > Statefull Inspection.

Re: Lan1 and lan2 are bridge mode. IPS doesn't work

Lei_Liu — Wed, 23 Mar 2022 09:28:58 GMT

Dear sir,

Thank you. the SMB appliance is a central management , i can't find "Advanced Settings > Statefull Inspection." on smartconsole.

Could you help me point our where it are?

Thank you very much.

BRs,

Lei

Re: Lan1 and lan2 are bridge mode. IPS doesn't work

G_W_Albrecht — Wed, 23 Mar 2022 09:41:51 GMT

No, i would suggest that you ask TAC for a solution !

Re: Lan1 and lan2 are bridge mode. IPS doesn't work

Lei_Liu — Wed, 23 Mar 2022 09:48:56 GMT

Dear sir,

I found It should be solved via sk102296.

Thank you for your help!

You are very nice.

BRs,

Re: Lan1 and lan2 are bridge mode. IPS doesn't work

G_W_Albrecht — Wed, 23 Mar 2022 09:55:54 GMT

I would have been reluctant to suggest GUIdbedit procedures 8).