topic Re: Smartmove for Cisco Firepower in SmartMove

Smartmove for Cisco Firepower

Prasanna — Wed, 25 Nov 2020 08:39:37 GMT

Hi Team,

Smartmove can be used to migrate Cisco ASA to Checkpoint as the available SK article. Will the same work for Cisco Firepower 4xxx series firewalls. If not, is there any way to migrate Firepower objects & policies to Check Point.

Re: Smartmove for Cisco Firepower

Ofir_Shikolski — Sun, 29 Nov 2020 07:31:46 GMT

Hi,

SmarMove support Cisco ASA V8.3 + - according to https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solutionid=sk115416

Re: Smartmove for Cisco Firepower

Attiq786 — Tue, 18 May 2021 11:35:02 GMT

Hello,

I am looking for a way to migrate Access Control, Nat policy and objects from Firepower Management Centre to the CheckPoint. I looked at the sk115416 but it only mentions ASDM or show run from ASA devices. nothing about FMC config migration. has someone done this before?

Regards

Attiq

Re: Smartmove for Cisco Firepower

Ofir_Shikolski — Wed, 19 May 2021 07:01:34 GMT

Hi,

Only Cisco ASA is supported.

We explorer Firepower locally managed as a new supported vendor.

Re: Smartmove for Cisco Firepower

Ted_Serreyn — Wed, 07 Jul 2021 21:41:00 GMT

I second this question. A search shows LOTS of cisco articles to migrate checkpoint to firepower. It would be nice to see one going the other way.

Re: Smartmove for Cisco Firepower

the_rock — Wed, 07 Jul 2021 22:22:00 GMT

I can only speak from my own experience...I used it fine with Cisco ASA and also ASA that had firepower built in (I guess they call it virtual instance??...not really sure) and worked in both cases. I honestly never tried it on dedicated Cisco firepower appliance, so could not tell you if that works or not.