topic How to size Harmony Connect SD WAN Branch Protection in SASE and Remote Access

How to size Harmony Connect SD WAN Branch Protection

franctorres — Sat, 24 Sep 2022 22:37:44 GMT

Hello mates good day, I have a question in the Harmony Connect SD WAN section... If I want to configure Harmony Connect for a Velocloud deployment, how many licenses I have to use? the 50 users minimum? or I have to size the right number of supported users for the Velocloud Appliance (510 model) ?

Regards

Re: How to size Harmony Connect SD WAN Branch Protection

Chris_Atkinson — Sat, 24 Sep 2022 23:31:56 GMT

Is the deployment consisting of a single branch only?

Typically you should license the correct number of users to be protected for the deployment as a whole, so long as it is more than the minimum.

A ratio of user:ip is applied where named users cannot be identified via your IDP.

Re: How to size Harmony Connect SD WAN Branch Protection

Chris_Atkinson — Sun, 25 Sep 2022 01:36:30 GMT

To clarify we're you referring to licensing or the following setup screen?

Re: How to size Harmony Connect SD WAN Branch Protection

franctorres — Sun, 25 Sep 2022 15:15:01 GMT

Hi Chris thanks for the response, I refer more to the number of licenses in a Bill of Materials or in Quote... also the deployment consists in either a only branch and a multiple branches.

The estimation in the configuration it may affect the performance?

Regards