topic Re: Remote access VPN - Use on site WAN-IP after VPN connection in SASE and Remote Access

Remote access VPN - Use on site WAN-IP after VPN connection

Mike_Sector — Fri, 13 Sep 2024 09:17:57 GMT

I am fairly new to Gaia R81.20 and have encountered an issue in a test lab.

I have installed and configured the IPSec VPN and Mobile Access modules. I can successfully establish a client-to-site VPN connection and reach my internal RDS server.

When I am connected to my VPN, I retain my local WAN IP. I would like to browse the internet using the WAN IP address of the remote site. How can I achieve this?

I also use OPNsense, where there is a checkbox called "Redirect Gateway" (Force all client-generated traffic through the tunnel).

I hope you guys can help.

Kind regards

Re: Remote access VPN - Use on site WAN-IP after VPN connection

_Val_ — Fri, 13 Sep 2024 12:36:32 GMT

Yes, it is possible.

See sk111995: You have to set Hub Mode / Route all traffic to gateway in Global Properties -> Remote Access -> Endpoint Connect -> Route all traffic to gateway -> set to "Yes"

Reference: https://community.checkpoint.com/t5/Remote-Access-VPN/I-would-like-disable-split-tunneling-for-vpn/m-p/31748

Re: Remote access VPN - Use on site WAN-IP after VPN connection

Mike_Sector — Sat, 14 Sep 2024 14:50:21 GMT

Thank you for your help.

I was using SecuRemote and that was not working. I used now Check Point Mobile for Windows and indeed your answer is correct.

Kind regards

Re: Remote access VPN - Use on site WAN-IP after VPN connection

PhoneBoy — Mon, 16 Sep 2024 12:43:27 GMT

Yes, SecuRemote doesn't support Office Mode, which is necessary for Route All Traffic to work.