topic Re: Clarification on Log Generation Mode (Aggregate Mode) in R82.10 in General Topics

Clarification on Log Generation Mode (Aggregate Mode) in R82.10

RemoteUser — Mon, 23 Mar 2026 12:36:28 GMT

Hi Mates!!!!
Hope you all doing well.

I have a few questions regarding a feature introduced in R82.10, specifically the Log Generation Mode, and in particular the Aggregate Mode:

Generates logs per session and combines multiple connection logs into a single log. Aggregate mode significantly reduces log volume and cloud storage costs.

From my understanding, this setting is applied globally across the policy packages managed by the Management Server. Also, it seems that it effectively changes the logging behavior from per-connection to per-session.

Could you please confirm if this understanding is correct?

Additionally, I would like to clarify the following:

If we switch to Aggregate Mode, does it impact all policies in terms of logging behavior (i.e., converting all logs to session-based)?
In case we decide to revert back to Standard Mode (for example, if we lose visibility on certain logs such as NAT), will the previous logging behavior be automatically restored as it was before?

Thank you in advance for your support.

Re: Clarification on Log Generation Mode (Aggregate Mode) in R82.10

PhoneBoy — Mon, 23 Mar 2026 21:50:50 GMT

You have always been able to configure "Per Connection" or "Per Session" logging on a per-rule basis.
Aggregate Mode applies only to rules where this wasn't previously configured.
Which means it should operate as you described.

Re: Clarification on Log Generation Mode (Aggregate Mode) in R82.10

RemoteUser — Thu, 26 Mar 2026 13:43:25 GMT

Just tested this in the lab:

When switching from Standard to Aggregated log mode, the change is applied to all rules, including the cleanup rule.

However, when switching back from Aggregated to Standard, the previous configuration is not automatically restored. This means you need to be careful (specially if you have a lot of rule in the policy pacakge) if you require more detailed logs again, you’ll have to manually reconfigure the rules.

Suggestion: it would be great if this feature could be applied per policy package rather than globally.

Re: Clarification on Log Generation Mode (Aggregate Mode) in R82.10

PhoneBoy — Fri, 27 Mar 2026 17:55:28 GMT

Ok, so it's actually enabling the setting in the rule itself.
This is good to know.