topic Re: CLINFR0329 in General Topics

CLINFR0329

C_M — Wed, 02 Oct 2019 17:04:30 GMT

While trying to change passwords in clish I get the following errors:

CLINFR0329 Invalid command:'set user admin password

CLINFR0329 Invalid command: 'set expert-password

Please advise.

Re: CLINFR0329

Danny — Wed, 02 Oct 2019 17:17:24 GMT

You either don‘t have the required permission to run these commands or you are not in Clish mode. Post a screenshot.

Re: CLINFR0329

PhoneBoy — Wed, 02 Oct 2019 18:04:39 GMT

If set expert-password doesn't work, you must be in an early version of Gaia.
The command should be set expert-password plain in that case.
set user admin password should work even in R75.40, though.
That said, you can also try set selfpasswd to change your password, assuming you are logging in as the admin user.

Re: CLINFR0329

C_M — Wed, 02 Oct 2019 18:22:27 GMT

R80.10

Re: CLINFR0329

C_M — Wed, 02 Oct 2019 18:31:56 GMT

See attached screenshot.

Re: CLINFR0329

PhoneBoy — Wed, 02 Oct 2019 20:44:05 GMT

Leave off CheckPoint from both commands.
You will be prompted for the password you wish to use.

Re: CLINFR0329

Maarten_Sjouw — Wed, 02 Oct 2019 20:59:00 GMT

try to use the Tab key while typing: set user admin pass<Tab> and see if it fills it to password and then hit enter to enter your new password.

Re: CLINFR0329

omar_1212 — Thu, 12 Sep 2024 12:06:36 GMT

Hey,

I am new to checkpoint here. Did you ever find what was the issue for this as I am stuck on this at the moment while trying to configure an out of the box checkpoint.

Thanks

Re: CLINFR0329

PhoneBoy — Thu, 12 Sep 2024 21:35:09 GMT

"Out of the box" please elaborate.
What hardware (if VM or Open Server, please specify the RAM/CPU/Disk allocated) and what version/JHF?