topic Down tunnels are not displayed in General Topics

Down tunnels are not displayed

Martin_Sykora — Fri, 07 Dec 2018 10:49:19 GMT

In R80.10. In SmartView Monitor in the Tunnels on Gateway view I only see tunnels that are up and tunnels that I know that are down are not displayed. In the Query Properties I have the State filter set to Any. Yet no down tunnels are shown.
When I check in the down tunnel's respective Tunnels on Community view I only see "No data".
At first I thought that this is just the way it is - tunnels that are down are not presented - but than I found this screenshot in a Tunnels on Gateway on the Internet where there are all kinds of states in the the view.

I am thinking that something is not right on my side. Did anybody ran across such behavior?

Re: Down tunnels are not displayed

Mike_A — Fri, 07 Dec 2018 14:39:23 GMT

I just looked at my SVM of "Tunnels on Gateway", without any filter, other than the GW name itself that needs to be selected, I show UP and DOWN tunnels. Along your top columns, do you have any filter enabled (Green), other than the ANY on the state?

Re: Down tunnels are not displayed

--JayJay-- — Tue, 25 Jun 2019 16:54:47 GMT

Hey Martin ,

Did you get this resolved?

I am seeing the same thing on R80.20.