https://community.checkpoint.com/t5/General-Topics/Bond/m-p/107858#M20594 <P>Hello good morning guys,</P><P>I have a GW r80.40 with two 10GB ports in bond1 connected a fiber cable to each different switch and if I use<BR />High availability (active / backup) on the switches should you put the VLAN in access mode?</P><P>And if I use 802.3ad, should this be configured on the switches in LACP?</P><P>thanks a lot for your answers guys.</P><P><SPAN>it is not a cluster HA</SPAN></P> Thu, 14 Jan 2021 17:22:01 GMT MardoqueoRob 2021-01-14T17:22:01Z https://community.checkpoint.com/t5/General-Topics/Bond/m-p/107858#M20594 <P>Hello good morning guys,</P><P>I have a GW r80.40 with two 10GB ports in bond1 connected a fiber cable to each different switch and if I use<BR />High availability (active / backup) on the switches should you put the VLAN in access mode?</P><P>And if I use 802.3ad, should this be configured on the switches in LACP?</P><P>thanks a lot for your answers guys.</P><P><SPAN>it is not a cluster HA</SPAN></P> Thu, 14 Jan 2021 17:22:01 GMT https://community.checkpoint.com/t5/General-Topics/Bond/m-p/107858#M20594 MardoqueoRob 2021-01-14T17:22:01Z https://community.checkpoint.com/t5/General-Topics/Bond/m-p/107863#M20595 <P>Greetings,</P><P>Check Point support differents methods for link agregattion (bondings). It's depend on your need and your topology.</P><P>Answering you, bond1 interface will have just one subnet? If yes, keep interface in access mode on switch side, else set trunk mode and set vlan id's according you wish.<BR /><BR />About 802.3ad, certainly you must enable LACP on switch side if you wish to work in active/active configuration.</P><P>Alisson Lima</P> Thu, 14 Jan 2021 20:50:07 GMT https://community.checkpoint.com/t5/General-Topics/Bond/m-p/107863#M20595 firewall1-gx 2021-01-14T20:50:07Z