Static Nat seems not working with multicast

minhhaivietnam — Sun, 15 Sep 2019 10:46:43 GMT

Hi all,

I have a topology running multicast:

router1(multicast receiver)----checkpoint r80----router2(RP)---router3(multicast sender)

all devices run pim-sm.

above network run fine without nat.

but when i set static nat on firewall: IP of router1---> translate to a.b.c.d

then on router1, I send "igmp join" toward to RP(router2). On log , i see that igmp packet is forwarded to firewall, but packet is not nated to a.b.c.d (above ip address). And not forwarded through firewall.

So my question is if checkpoint r80 supports multicast nat source? If yes , how i can config it?

Thank you!!

Re: Static Nat seems not working with multicast

PhoneBoy — Mon, 16 Sep 2019 00:13:27 GMT

We do not support NAT with PIM.
https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solutionid=sk157854

topic Static Nat seems not working with multicast in General Topics

Static Nat seems not working with multicast

Re: Static Nat seems not working with multicast