topic Re: VSX Cluster error :Interface cannot be set. More than one default gateway is defined. in Firewall and Security Management

VSX Cluster error :Interface cannot be set. More than one default gateway is defined.

Javier001 — Tue, 22 Jun 2021 21:33:39 GMT

Hello,

I´m configuring a new VSX Cluster with 2 bond interfaces, using Sync interface for state synchronization and Mgmt port as usual.

I received the following error:

Installing default Policy...

Successfully installed default policy ...

Generating VSX Configuration for VSX_CLUSTER

Pushing VSX Configuration to VSX_CLUSTER

FW 2: processed 9% of configuration...

FW 1: processed 9% of configuration...

Failed to configure VSX_CLUSTER with the following errors:

FW 2 :Interface cannot be set. More than one default gateway is defined.

FW 1 :Interface cannot be set. More than one default gateway is defined.

VSX Processing Completed with Errors

Operation has failed.

I only have one default router to switch gateway for each FW. Also, I have a LOM inteface with the same next_hop.

Thank in advances!

Re: VSX Cluster error :Interface cannot be set. More than one default gateway is defined.

HeikoAnkenbrand — Tue, 02 Jun 2020 20:47:13 GMT

Hi @Javier001

Did you set a default route during the GAIA installation?

If so, delete them.

Re: VSX Cluster error :Interface cannot be set. More than one default gateway is defined.

Javier001 — Wed, 03 Jun 2020 08:09:24 GMT

Hi @Heiko
I can´t do that. Firewalls are behind many networks before reaching the MDS.

I have connected the Sync interfaces but one of them don´t have link detected...So I think that´s where the problems come from.

Is it possible build a bonding interface up with a Sync interface and a Eth interface?

Thank you

Re: VSX Cluster error :Interface cannot be set. More than one default gateway is defined.

_Val_ — Wed, 03 Jun 2020 10:24:33 GMT

This looks like the issue described in sk101165

Please follow the SK to resolve. If it is still a problem, open a support case with TAC

Re: VSX Cluster error :Interface cannot be set. More than one default gateway is defined.

_Val_ — Wed, 03 Jun 2020 10:25:53 GMT

Not related to sync. Still, you need to fix sync before moving forward.

Re: VSX Cluster error :Interface cannot be set. More than one default gateway is defined.

Javier001 — Wed, 03 Jun 2020 11:09:47 GMT

You are right. There was another static route configured not shown running "show route all" on clish. If you run from expert: clish -c "show configuration" | grep route, you can see ALL routes. Other way is cancel vsx mode using "vsx mode off" and then login on Gaia to see ALL routes.

Thank you.