VSX Failover Issue

Rano — Fri, 21 Aug 2020 06:01:41 GMT

Hello Everyone,

I need some help as recently I have upgraded customer VSX environment to latest R80.30 Hotfix . All goes well as per plan only on the last minute during manual fail-over I have encountered a problem in which out of 5 only 1 VSX failover correctly and 4 is still showing standby.

Can seniors please suggest how I can failover back to its original position. Thanks

Before>

output from PS2:>

You should see the following output:

ID Unique Address Assigned Load State Name

1 10.10.1.1 100% ACTIVE PS-1
2 (local) 10.10.1.2 0% STANDBY PS-2

Virtual Devices Status on each Cluster Member
=============================================

ID | Weight| PS-1| PS-2
| | | [local]
-------+-------+-----------+-----------
3 | 10 | STANDBY | ACTIVE
4 | 10 | STANDBY | ACTIVE
6 | 10 | STANDBY | ACTIVE
7 | 10 | STANDBY | ACTIVE
9 | 10 | STANDBY | ACTIVE
---------------+-----------+-----------
Active | 0 | 5
Weight | 0 | 50
Weight (%) | 0 | 100

-----------------------------------------------------

Manual Failover on the MDS was done after the upgrade

After >

Output from PS2:>

Cluster Mode: Virtual System Load Sharing (Primary Up)

1 10.10.1.1 100% ACTIVE PS-1
2 (local) 10.10.1.2 0% STANDBY PS-2

Virtual Devices Status on each Cluster Member
=============================================

ID | Weight| PS-1| PS-2
| | | [local]
-------+-------+-----------+-----------
3 | 10 | ACTIVE | STANDBY
4 | 10 | ACTIVE | STANDBY
6 | 10 | ACTIVE | STANDBY
7 | 10 | ACTIVE | STANDBY
9 | 10 | STANDBY | ACTIVE
---------------+-----------+-----------
Active | 4 | 1
Weight | 40 | 10
Weight (%) | 80 | 20

Re: VSX Failover Issue

G_W_Albrecht — Fri, 21 Aug 2020 07:42:55 GMT

I would suggest to consult TAC asap to resolve this !

topic Re: VSX Failover Issue in Firewall and Security Management

VSX Failover Issue

Re: VSX Failover Issue