topic Re: CPview on R80.30 wrong Mbps indications in Firewall and Security Management

CPview on R80.30 wrong Mbps indications

marcinw — Mon, 08 Mar 2021 09:42:06 GMT

Hi ,

Just after upgrading from 77.30 to 80.30 I've noticed that cpview shows wrong bandwidth utilization, I run speedtest with 100 Mbs but cpview show around 10 (please check attachment) Is there any bug or do I have to configure something ?

Re: CPview on R80.30 wrong Mbps indications

the_rock — Mon, 08 Mar 2021 14:07:49 GMT

I checked this for couple of my customers and its very accurate. Though they are both on R80.40 version, cant speak for R80.30...maybe you can check with TAC on it.

Andy

Re: CPview on R80.30 wrong Mbps indications

marcinw — Mon, 08 Mar 2021 14:16:27 GMT

sorry, actualy you are right FW is on 80.30 , but mgmt 80.40, so it is working for you not for me

Re: CPview on R80.30 wrong Mbps indications

the_rock — Mon, 08 Mar 2021 14:19:10 GMT

Well, that should not matter at all actually...you might want to open TAC case and have them check, for sure.

Andy

Re: CPview on R80.30 wrong Mbps indications

the_rock — Mon, 08 Mar 2021 14:21:17 GMT

By the way, maybe I calculated this wrong, where did you get number 10 Mbps from that screenshot?

Re: CPview on R80.30 wrong Mbps indications

marcinw — Mon, 08 Mar 2021 14:37:58 GMT

The last column "Mbp" shows 10 times less value than should

Re: CPview on R80.30 wrong Mbps indications

the_rock — Mon, 08 Mar 2021 14:41:00 GMT

Normal;ly, I always look at the end where you add them all together or did you only calculate for one specific interface?

Re: CPview on R80.30 wrong Mbps indications

marcinw — Mon, 08 Mar 2021 14:47:00 GMT

on 77.30 I had no problem with that, bandwidth utilization was always accurate on each interface , also I see there is no "top protocols" , "top connections".

Re: CPview on R80.30 wrong Mbps indications

the_rock — Mon, 08 Mar 2021 14:50:22 GMT

Sorry, but Im out of ideas really...I would suggest open TAC case and show them exactly that. I cant say for sure if its something with R80.30, but I had not seen this problem in R8040, so one thing you could do is upgrade the firewall.

Andy

Re: CPview on R80.30 wrong Mbps indications

PhoneBoy — Mon, 08 Mar 2021 19:53:45 GMT

The issue with Top Protocols is fixed with a recent JHF.
See: https://supportcenter.checkpoint.com/supportcenter/portal?action=portlets.SearchResultMainAction&eventSubmit_doGoviewsolutiondetails=&solutionid=sk167903