https://community.checkpoint.com/t5/Firewall-and-Security-Management/VPN/m-p/95887#M7445 <P><SPAN>Worked perfectly. Thank you very much</SPAN></P> Wed, 02 Sep 2020 20:26:41 GMT Rodrigo_Mezetti 2020-09-02T20:26:41Z https://community.checkpoint.com/t5/Firewall-and-Security-Management/VPN/m-p/95689#M7431 <P>Dear,&nbsp; I-am use R80.10 cluster .My vpn through endpoint security was running normally, until I needed to activate ipsec on the cluster to proceed with a serial connection to the site with azure. It happens that now my client who are using the endpoint, needing to reconnect every time access was done, where he places the destination IP, user and makes the connection. If I try to reconnect it informs that it is loading new topology and disconnects, then I need to redo the tunnel again. Can you help me</P> Mon, 31 Aug 2020 16:17:21 GMT https://community.checkpoint.com/t5/Firewall-and-Security-Management/VPN/m-p/95689#M7431 Rodrigo_Mezetti 2020-08-31T16:17:21Z https://community.checkpoint.com/t5/Firewall-and-Security-Management/VPN/m-p/95697#M7434 <P>Most likely the fact you had to enable IPsec VPN modified the Link Selection properties previously applied.</P><P>You can check the following SK to force Remote Access VPN through one address&nbsp;<A href="https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&amp;solutionid=sk92383" target="_self">sk92383</A></P> Mon, 31 Aug 2020 17:25:13 GMT https://community.checkpoint.com/t5/Firewall-and-Security-Management/VPN/m-p/95697#M7434 KennyManrique 2020-08-31T17:25:13Z https://community.checkpoint.com/t5/Firewall-and-Security-Management/VPN/m-p/95887#M7445 <P><SPAN>Worked perfectly. Thank you very much</SPAN></P> Wed, 02 Sep 2020 20:26:41 GMT https://community.checkpoint.com/t5/Firewall-and-Security-Management/VPN/m-p/95887#M7445 Rodrigo_Mezetti 2020-09-02T20:26:41Z