Weird default route after upgrade

Maarten_Sjouw — Thu, 25 Oct 2018 10:23:54 GMT

I was preparing 2 12400's for installation, 1 was clean installed with R77.1 and 1 had a used R77.30 installation on it.

I copied the deployment agent 1573 onto it, updated CPUSE and copied the Check_Point_R80.10_T462_Fresh_Install_and_Upgrade_from_R7X.tgz file, which I then imported.

Next step was installer clean-install <the imported package> and let it run and reboot.

All looked fine untill I was looking at the Mgmt interface, it had kept it's IP, and the default route and this is where it gets weird:

gw-7> show configuration static-route
set static-route default nexthop gateway address rt219bb100-100- on

I tried to add the correct route:

gw-7> set static-route default nexthop gateway address 100.100.219.9 on
RTGRTG0019 syntax error

With show route no routes are shown.

Adding any static route will just give me the same syntax error??

Re: Weird default route after upgrade

Maarten_Sjouw — Thu, 25 Oct 2018 10:59:05 GMT

First I tried to clear the Gaia config by deleting the config database, cd /config and rm-r * However this did not change anything in th IP fielde.

Ok, found a workaround to the problem:

Go into expert mode and edit the file /etc/routed0.conf and make sure the correct next hop is entered there with the default gateway.

Now start the First time wizard and when it shows fill out the correct default gateway there as well, now finish the FTW and all is back to normal.

topic Weird default route after upgrade in Firewall and Security Management

Weird default route after upgrade

Re: Weird default route after upgrade