topic Re: atp command and more on Autonomous Threat Prevention commands in Firewall and Security Management

atp command and more on Autonomous Threat Prevention commands

Don_Paterson — Thu, 15 Sep 2022 12:55:38 GMT

The Threat Prevention Admin Guide seems to have no reference to the atp command.

I discovered and used 'atp status' command but cannot find anything interesting on it.

A reboot was the fix but still not sure what caused the ATP SmartConsole error.

See attached.

References:
https://sc1.checkpoint.com/documents/R81.10/WebAdminGuides/EN/CP_R81.10_ThreatPrevention_AdminGuide/Topics-TPG/The_Check_Point_Threat_Prevention_Solution.htm

https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solutionid=sk167109

https://community.checkpoint.com/t5/Threat-Prevention/Autonomous-Threat-Prevention-service-is-down/td-p/151146

Re: atp command and more on Autonomous Threat Prevention commands

PhoneBoy — Thu, 15 Sep 2022 15:22:13 GMT

I do see a reference to atp commands here: https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solutionid=sk172203&partition=Advanced&product=Zero
However, you're right: there doesn't appear to be any documentation on these commands.

Re: atp command and more on Autonomous Threat Prevention commands

Don_Paterson — Thu, 15 Sep 2022 16:07:19 GMT

Yes, it is referenced there but only to show 'atp restart', and nothing else (no links or explanations).

As expected the atp command, when it is run on it's own, shows the 'usage' but the documentation on it is nowhere to be found.

Thanks for getting back to me.

Re: atp command and more on Autonomous Threat Prevention commands

Tal_Paz-Fridman — Fri, 16 Sep 2022 15:32:48 GMT

More information is available in the ATRG for Autonomous Threat Prevention:

https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solutionid=sk169952

In the past the product name was Infinity Threat Prevention hence all the command are use itp.

I will ask for the SK to be updated to use atp.

Re: atp command and more on Autonomous Threat Prevention commands

Don_Paterson — Fri, 16 Sep 2022 15:45:48 GMT

Thank you 🙂

I knew it was previously itp but did not think to search itp status in Support.

I just ran 'autoupdatercli show' and noticed that ATP components all fall under the header 'product-name: itp' .
Small thing.

Regards,

Don