ElasticXL switch configuration for data interfaces ?

Wolfgang — Fri, 21 Mar 2025 13:00:55 GMT

Are there any special configuration on the switches needed for data interfaces ?

We're playing with ElasticXL and having some trouble after adding a second member. Most of the traffic does not go through the gateway. If we set one member down everything is fine. We can change the active node and all is fine. But with more then one node active everything stucks in nirvana or dev 0...

On the connected switch we get a lot of MAC flappings between Management and Data port.....

Mar 20 19:36:12.068: %SW_MATM-4-MACFLAP_NOTIF: Host 0000.0002.0200 in vlan XX is flapping between port Gi1/0/9 and port Gi2/0/1
Mar 20 19:36:12.123: %SW_MATM-4-MACFLAP_NOTIF: Host 0000.0002.0201 in vlan XX is flapping between port Gi1/0/1 and port Gi2/0/9
Mar 20 19:36:26.145: %SW_MATM-4-MACFLAP_NOTIF: Host 0000.0002.0201 in vlan XX is flapping between port Gi1/0/1 and port Gi2/0/9
Mar 20 19:36:27.077: %SW_MATM-4-MACFLAP_NOTIF: Host 0000.0002.0200 in vlan XX is flapping between port Gi2/0/1 and port Gi1/0/9
Mar 20 19:36:42.085: %SW_MATM-4-MACFLAP_NOTIF: Host 0000.0002.0200 in vlan XX is flapping between port Gi1/0/9 and port Gi2/0/1

Gi1/0/9 => Management-Port

Gi2/0/1 => Data-Port

What are these MAC-addresses ost 0000.0002.0201 and 0000.0002.0200

Re: ElasticXL switch configuration for data interfaces ?

_Val_ — Mon, 24 Mar 2025 14:25:52 GMT

These are cluster discovery MACs. You need to disable snooping on adjacent ports, AFAIK

Re: ElasticXL switch configuration for data interfaces ?

AkosBakos — Tue, 25 Mar 2025 14:18:47 GMT

Did you install the one and only JHF on the top of the R82, right??

topic Re: ElasticXL switch configuration for data interfaces ? in Firewall and Security Management

ElasticXL switch configuration for data interfaces ?

Re: ElasticXL switch configuration for data interfaces ?

Re: ElasticXL switch configuration for data interfaces ?