OSPF static routes propagate

Bernardes — Tue, 26 Mar 2024 20:23:36 GMT

Dear All,

Sorry for the simple question, but I couldn't find this information clearly in the guide.

I need to configure OSPF on a Check Point appliance and I need it to propagate static routes from the routing table.

However, in the Gaia settings, I couldn't find where to specify which network I'm going to advertise. I only have the option to add an interface to a specific area.

Comparing with a Cisco router, the equivalent command to what I'm looking for in Check Point would be as follows:

Configure the static route
Router(config)# ip route 192.168.2.0 255.255.255.0 192.168.1.2

Propagate this route via OSPF
Router(config)# router ospf 1
Router(config-router)# network 192.168.1.0 0.0.0.255 area 0

This way, I advertise the network 192.168.1.0/24 through OSPF area 0.

I couldn't find an equivalent command in Gaia.

Thank you in advance.

topic OSPF static routes propagate in Firewall and Security Management

OSPF static routes propagate