topic Re: LOM Displaying "page cannot be displayed" in Firewall and Security Management

LOM Displaying "page cannot be displayed"

sabeelshakeel — Wed, 26 Jul 2023 15:47:32 GMT

I have configured the LOM on my checkpoint gateways a few months back and confirmed that they worked fine. I recently checked to see if i can log in again, but i am displayed with "page cannot be displayed" and the connection times out from my VPN.

I have checked the firewall rules and they are still in place and untouched.

Have reconfigured the LOM via IPMI and even reset is in the IPMI (and re-configured, including the username) but no luck.

Does anybody know how to resolve this ?

Telent is not allowed in our environment, so couldn't do a telnet test and unsure how to check on IPMI if the port 443 is open.

Best Regards,

Sabeel

Re: LOM Displaying "page cannot be displayed"

the_rock — Wed, 26 Jul 2023 15:55:35 GMT

Tried all of below?

Andy

https://support.checkpoint.com/results/sk/sk170915

If so, I would contact TAC to see what else can be done.

Re: LOM Displaying "page cannot be displayed"

PhoneBoy — Wed, 26 Jul 2023 16:52:29 GMT

"netcat" is a binary that is available on all Check Point gateways (including SMB ones) in expert mode.
It can be used to perform this basic connectivity test (similar to a telnet).