ethtool show port type = OTHER for eth1.04

AnimaliSoli — Fri, 14 Jul 2023 08:01:00 GMT

Hello,

I need a little help and clarification on this topic: What is an "Other" port type? What does it means, please?

On a 6200P appliance I was searching for any available interface.

I saw the interface state and configuration using cpview and "ethtool eth1-04" and the Port type is "OTHER", not twisted pair or FIBRE. The Field for "supported port" is blank.

Should I consider it available and working?

Where I can find more information about that state of the port?

Here below the output (a short version) and below the Gaia Versions:

cpview:

ethtool eth1-04

Settings for eth1-04:
Supported ports: [ ]
Supported link modes: 1000baseX/Full
10000baseSR/Full
Supported pause frame use: Symmetric
Supports auto-negotiation: Yes
Supported FEC modes: Not reported
Advertised link modes: 1000baseX/Full
10000baseSR/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Advertised FEC modes: Not reported
Speed: Unknown!
Duplex: Unknown! (255)
Port: Other
PHYAD: 0
Transceiver: internal
Auto-negotiation: off
Supports Wake-on: g
Wake-on: g
Current message level: 0x0000000f (15)
drv probe link timer
Link detected: no

This is Check Point CPinfo Build 914000227 for GAIA
[CPFC]
HOTFIX_TEX_ENGINE_R8040_AUTOUPDATE
[MGMT]
HOTFIX_R80_40_JUMBO_HF_MAIN Take: 197

Check Point's software version R80.40 - Build 156
kernel: R80.40 - Build 144

thanks in advanced

Re: ethtool show port type = OTHER for eth1.04

PhoneBoy — Fri, 14 Jul 2023 21:55:54 GMT

My guess is there is no SFP plugged into the port (thus why it says OTHER).
The port also appears to be disabled.
In any case, it suggests it’s available to use.

topic ethtool show port type = OTHER for eth1.04 in Firewall and Security Management

ethtool show port type = OTHER for eth1.04

Re: ethtool show port type = OTHER for eth1.04