LOM for 6900 set IP

Daniel_Kavan — Wed, 02 Nov 2022 18:21:43 GMT

Hi,

Refresher onhow to configure the IP address, mask and gw of the LOM on a 6900 appliance. There is no LED panel in front so I'm planning this. We are on the command line but unsure of the commands. Going in this way with admin / admin & putting in the ip address. Working on the syntax now.

Connect a serial terminal emulator to the serial console port using the following parameters:

Baud rate: 9600
Data: 8 bit
Parity: none
Stop: 1 bit
Flow control: none

Connect a 10/100/1000 Mbit Network cable to the Console port.

Log in to console with these credentials (assuming the user did not change the 'admin' password):

User: admin
Password: admin
was able to set up eth1 for INT access (SSH & web ui)
set lom ip-address trying to figure out how to get to the LOM console

Re: LOM for 6900 set IP

Daniel_Kavan — Wed, 02 Nov 2022 18:25:47 GMT

sk92986

[Expert@HostName:0]# lomipset <LOM_IP_ADDRESS> <LOM_NETMASK> <LOM_DEFAULT_GW_ADDRESS>

topic Re: LOM for 6900 set IP in Firewall and Security Management

LOM for 6900 set IP

Re: LOM for 6900 set IP