https://community.checkpoint.com/t5/Firewall-and-Security-Management/cluster-ID-value-with-R80-30-jumbo-and-R81/m-p/141225#M21789 <P>R80.30 with 3.10 kernel?</P> <P>Per R80.40 (<SPAN>sk160736) and above:</SPAN></P> <UL> <LI>Support for Cluster Control Protocol (CCP) in Unicast mode for any number of cluster members eliminating the need for CCP Broadcast, Multicast or Automatic modes.</LI> <LI>Eliminated the need for MAC Magic configuration when several clusters are connected to the same subnet.</LI> </UL> Fri, 11 Feb 2022 03:01:45 GMT Chris_Atkinson 2022-02-11T03:01:45Z https://community.checkpoint.com/t5/Firewall-and-Security-Management/cluster-ID-value-with-R80-30-jumbo-and-R81/m-p/141219#M21787 <P>Hello -- it appears that command I'm familiar with has been deprecated with recent JUMBO on R80.30 and beyond.</P><P>Ultimately, I need to check/validate the cluster_ID_value.&nbsp;&nbsp;&nbsp;</P><P>The command I'm familiar with is as follows:</P><P><FONT color="#008000"><STRONG>(expert mode)&nbsp; # cphaconf cluster_id get</STRONG></FONT></P><P><FONT color="#008000"><STRONG>(expert mode)&nbsp; # cphaconf cluster_id set&nbsp; &lt;value&gt;</STRONG></FONT></P><P>This syntax doesn't work on R80.30 with recent Jumbo and suggests you read of sk25977.</P><P>However, the SK25977 only references this specific command and not a replacement for R80.30+ with JUMBO, R81+, etc.</P><P><A href="https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&amp;solutionid=sk25977" target="_blank" rel="noopener">Connecting multiple clusters to the same network segment (same VLAN, same switch)</A></P><P>Please help.&nbsp;&nbsp; -GA</P> Thu, 10 Feb 2022 23:17:45 GMT https://community.checkpoint.com/t5/Firewall-and-Security-Management/cluster-ID-value-with-R80-30-jumbo-and-R81/m-p/141219#M21787 Garrett_DirSec 2022-02-10T23:17:45Z https://community.checkpoint.com/t5/Firewall-and-Security-Management/cluster-ID-value-with-R80-30-jumbo-and-R81/m-p/141225#M21789 <P>R80.30 with 3.10 kernel?</P> <P>Per R80.40 (<SPAN>sk160736) and above:</SPAN></P> <UL> <LI>Support for Cluster Control Protocol (CCP) in Unicast mode for any number of cluster members eliminating the need for CCP Broadcast, Multicast or Automatic modes.</LI> <LI>Eliminated the need for MAC Magic configuration when several clusters are connected to the same subnet.</LI> </UL> Fri, 11 Feb 2022 03:01:45 GMT https://community.checkpoint.com/t5/Firewall-and-Security-Management/cluster-ID-value-with-R80-30-jumbo-and-R81/m-p/141225#M21789 Chris_Atkinson 2022-02-11T03:01:45Z