topic Re: Managing 2 FWs in Azure Cloud with SmartConsole in Cloud Firewall

Managing 2 FWs in Azure Cloud with SmartConsole

Olukayode_Adegb — Thu, 13 Sep 2018 14:11:35 GMT

Hello,

I have set up 2 FWs on Azure cloud. However, the 2 FWs I set up are not showing up in the SmartConsole.

Looking for suggestion on what may likely be the problem.

Regards

Julien_Moreau — Thu, 13 Sep 2018 14:15:43 GMT

Hi,

What do you mean by not showing up in smartconsole. Did you try to configure SIC or is your plan about configuration of autoprovisionning service ?

Coul you elaborate a bit more about the tasks you acheive so far ?

Danny — Thu, 13 Sep 2018 14:22:29 GMT

Not "showing up" in SmartConsole?

Did you actually create them in SmartConsole?

The procedure is described here: Deploying a Check Point Cluster in Microsoft Azure > SmartConsole Configuration.

Check Point also provides YouTube videos for these procedures: https://www.youtube.com/watch?v=i7H_bAk8r0Y

Olukayode_Adegb — Thu, 13 Sep 2018 19:18:41 GMT

Hello,

Yes. I configured SIC

I am very new on setting up Checkpoint FW on Azure cloud.

I have created the VM in Azure cloud with Checkpoint CloudGuard IaaS R80.10 Scale Set

I have set the Management server as well as the SIC key.

I tried to add the FW GW on SmartConsole using the following Network Object > Gateway and Server > Gateway but I'm getting this error message

Julien_Moreau — Sun, 19 Dec 2021 09:51:23 GMT

Hi,

If you are doing a Scale Set, you doesn't have to manually configure SIC.. This has to be done automatically leveraging autoprovisioning service.

Are you sure that your management server can communicate to your Azure GW ?

Did you properly follow each steps on the below documentation ?:

~~Virtual Machine Scale Sets for Azure R80.10 Administration Guide~~

This link was edited by Check Point on 19 Dec 2021 because this book was obsoleted by:

Could you share with us:

- the tag applied on your VMSS (Go to Virtual Machine Scale Set, select yours --> Tag)

- SSH on the management and output of "autoprov-cfg show all command"