----------------------- ethtool ethsBP1-02 ----------------------- Settings for ethsBP1-02: Supported ports: [ ] Supported link modes: 10000baseKR/Full 40000baseKR4/Full 40000baseCR4/Full 40000baseSR4/Full 40000baseLR4/Full 25000baseCR/Full 25000baseKR/Full 25000baseSR/Full 100000baseKR4/Full 100000baseSR4/Full 100000baseCR4/Full 100000baseLR4_ER4/Full Supported pause frame use: Symmetric Supports auto-negotiation: Yes Supported FEC modes: None BaseR RS Advertised link modes: 10000baseKR/Full 40000baseKR4/Full 40000baseCR4/Full 40000baseSR4/Full 40000baseLR4/Full 25000baseCR/Full 25000baseKR/Full 25000baseSR/Full 100000baseKR4/Full 100000baseSR4/Full 100000baseCR4/Full 100000baseLR4_ER4/Full Advertised pause frame use: Symmetric Advertised auto-negotiation: Yes Advertised FEC modes: Not reported Speed: Unknown! Duplex: Unknown! (255) Port: Other PHYAD: 0 Transceiver: internal Auto-negotiation: on Supports Wake-on: g Wake-on: d Current message level: 0x00000004 (4) link Link detected: no ----------------------- ethtool -i ethsBP1-02 ----------------------- driver: mlx5_core version: 5.5-1.0.3 (13 May 22) firmware-version: 16.29.2002 (CP_0000000004) expansion-rom-version: bus-info: 0000:18:00.0 supports-statistics: yes supports-test: yes supports-eeprom-access: no supports-register-dump: no supports-priv-flags: yes ----------------------- ethtool -k ethsBP1-02 ----------------------- Features for ethsBP1-02: rx-checksumming: on tx-checksumming: off tx-checksum-ipv4: off tx-checksum-ip-generic: off [fixed] tx-checksum-ipv6: off tx-checksum-fcoe-crc: off [fixed] tx-checksum-sctp: off [fixed] scatter-gather: off tx-scatter-gather: off tx-scatter-gather-fraglist: off [fixed] tcp-segmentation-offload: off tx-tcp-segmentation: off tx-tcp-ecn-segmentation: off [fixed] tx-tcp6-segmentation: off tx-tcp-mangleid-segmentation: off udp-fragmentation-offload: off [fixed] generic-segmentation-offload: off generic-receive-offload: off large-receive-offload: off rx-vlan-offload: on tx-vlan-offload: on ntuple-filters: off receive-hashing: on highdma: on [fixed] rx-vlan-filter: on vlan-challenged: off [fixed] tx-lockless: off [fixed] netns-local: off [fixed] tx-gso-robust: off [fixed] tx-fcoe-segmentation: off [fixed] tx-gre-segmentation: on tx-ipip-segmentation: off [fixed] tx-sit-segmentation: off [fixed] tx-udp_tnl-segmentation: on fcoe-mtu: off [fixed] tx-nocache-copy: off loopback: off [fixed] rx-fcs: off rx-all: off tx-vlan-stag-hw-insert: on rx-vlan-stag-hw-parse: off [fixed] rx-vlan-stag-filter: on [fixed] busy-poll: off [fixed] tx-gre-csum-segmentation: on tx-udp_tnl-csum-segmentation: on tx-gso-partial: on tx-sctp-segmentation: off [fixed] rx-gro-hw: off [fixed] l2-fwd-offload: off [fixed] hw-tc-offload: off rx-udp_tunnel-port-offload: on ----------------------- ethtool -g ethsBP1-02 ----------------------- Ring parameters for ethsBP1-02: Pre-set maximums: RX: 8192 RX Mini: 0 RX Jumbo: 0 TX: 8192 Current hardware settings: RX: 1024 RX Mini: 0 RX Jumbo: 0 TX: 1024